For technical support call Donkee™ Products
(800) 345-7186  (626) 579-1989 or Fax (626) 579-1994
Mon - Fri   10am. -  5pm.  PST
keith@donkee.com

Tips:
a)  Mark the bottle caps A & B make sure to put cap A on A & B cap on B
b)  To gage the cure of the product, use the extra material in the cup;
      as soon as it is ready the mold will be too.

1.   Pour component "A" into first measuring cup (provided). Aprox.1 oz. (third line level) to make one insert.
2.   Pour the same amount of "B" into second measuring cup.
3.   Add color pigment to component "B" in the measuring cup.
(since the re-formulation of component  "A",
use half the amount of color specified on the color chart).
      a. Use a pinch of mica to Pearlize or Optional for "B" component:
      b. Add 1/3 of a teaspoon of Non-Slick ProActive to slow the release of thumb solids or thumb inserts,

the more you add, the slower the release, this can be used

also to give the appearance of a reactive bowling ball.

Note: Please use non-wooden stir stick. Preferably a plastic knife (provided).

4.   Mix color thoroughly and then proceed.

5.   Pour component "A" into "B" and mix until you feel a slight temperature change

in the measuring cup (for about 15 seconds or so).

6.   Pour mixed components immediately into bowling ball or molds; before mixture gets

too warm.   

7.   Allow 15 minutes to cure. Follow instructions on mold chart to remove molds or    solids

K E E P   A W A Y    F R O M    C H I L D R E N!!

CAUTION: This material contains a resin which may cause eye irritation or allergic response such as skin irritation or dermatitis.  HARMFUL IF SWALLOWED.  In case of skin contact, wash immediately with soap and water; for eyes, flush with plenty of water for 15 minutes and consult a physician immediately. Remove and wash contaminated clothing before reuse.  Use with adequate ventilation.